How Often Should a Water Softener Regenerate?

All water softeners need to go through what is called regeneration. Regeneration is when the resin is cleaned and it is a very important part of the process within a water softener. This is the portion of the tank that works to keep your water soft and it needs the salt to keep it clean. Allowing the machine to do what it was intended to do, keep your water soft. This is something that needs to be done on a very regular basis because if it is not then the machine will break down and stop working. Then you will have problems on your hand bigger than hard water. Regeneration needs to take place normally every three to six days, but that depends on some various factors.

Water Softener Regeneration

Many of the units today are automatically set to regenerate once a week. This is determined based on the amount of water used, the amount of people in the house and the size of the resin tank involved. It is often best to speak to a water filtration specialist when deciding how long it should be set for. More often than not when they system is being set up or on a maintenance visit they will work to set it up for you based on your particular situation. If it doesn’t regenerate soon enough, water may start to taste salty or you may notice other problems starting with the softener. It is possible that the brine tank might begin to overflow which is always a way that it could notify you of a problem.

Most of the time, unless you have a manual regeneration tank it will be set to automatically go off so you will not have to worry about the regeneration cycle at all. With a manual system, this is the only time you will be required to go down and start the regeneration process by yourself. Other systems are on timers that are electric or similar to that of a turn knob timer. You turn the timer and it clicks off every so many days. Regeneration is a very important part of the process when it comes to your water softener. In fact, it is just a normal part of the process and must happen for the system to be rendered useful. If regeneration does not occur the system will break down and it could be very costly to repair.

Conclusion

Take away points to remember are that it is always a good idea to let a trained professional set up and determine the frequency of the regeneration cycle. They have a good idea of how to accurately calculate the steps in the process of water softening. If it is something that is done by an untrained person, issues may arise. That doesn’t mean that you shouldn’t understand your machine, as you really should, just be okay leaving it to the professionals. Most importantly remember that regeneration is part of the softening process and needs to be done on a regular basis for the best efficiency.

1 Comment
  1. Reply Claire July 25, 2017 at 4:27 pm

    Does the softner always show the day it is going to regenerate.

Leave a reply

Unified Water
12424 Wilshire Blvd #1140 Los Angeles CA 90025
Tel:+1 785-455-8931